Warp and Hopper dont fit together anymore...

[Bubonic Plauge]

I am currently using a Ricochet on my warpfeed. Recently it has become loose. I have no idea how.

Anyone have any easy/quick suggestions as to how I might be able to tighten up the fit a bit>? I was considering smering epoxy on my hopper to add girth.

Thanks

[-=Squid=-]

I dont know how you passed this option, and the best option, by...a bit of electrical tape.

[Bubonic Plauge]

Tried elec tape. It just got smered or "pushed" up off the nect of the hopper, such that it wasnt inside the warp.

=(

[Matt_mg]

Tried tightening your warp shells? Stuff just doesn't come loose without a reason...

[Paintchucker]

Yes, tightning sounds like the answer. I doubt that time has caused the warp plastic to expand and the hopper plastic to shrink at the same time

What you might want to try is a little electric tape around the hopper tube, then untighten the warp and spread it apart slightly. Insert the hopper, snug the warp body, then tighten it all back up. That should take care of your "got smered or "pushed" up off the nect " problem...

[cheetah256]

i can't find the link, but someone glued a bit of sandpaper to the inner ring of the hopper holder on their warp. it made the diameter a bit smaller, and added a bit of friction. just somethign to try : )

[arsonpaintball06]

tape is the way 2 go 2 fix it

[-=Squid=-]

Also, you can just buy a hopper spacer for like one buck...

[Wc Keep]

tunaman suggests the dye feed spacer whenever something like this happens.

but try tightening the shells.

[personman]

Originally posted by cheetah256
i can't find the link, but someone glued a bit of sandpaper to the inner ring of the hopper holder on their warp. it made the diameter a bit smaller, and added a bit of friction. just somethign to try : )

That was LoadSM5

What I did was glue a small peice of medium grit sandpaper on the inside of one of my warp halves. Then you loosen the top 3 screws on your warp. Drop your hopper in and tighten the whole thing down. The grit keeps the revy from spinning and the extra bit of material keeps everything nice and tight. I was too cheap and impatient to buy a hopper spacer. Between that and my warp hose running up through my revy it's very solid.

[SuiciDal Sn Y p ER]

...or you can just go get some o-rings for your rico

[Bubonic Plauge]

Wow, you all are awesome. Thanks for the replies. Gotta love AO, posted this last night and bam.

Thanks again