prices and availability on Warp board, motor, and sensor

[FeelTheRT]

I was wondering if it was possible to buy the board, motor, and vibration sensor? If so, how much would it be total?

[Gunga]

Dunno about the board and sensor, but you can pick up the motor at Radio Shack for under $5 I think.

[ah137]

I got a board for 25 at the open house, the motor from radio shack is 3-4 dollars, sensor your probably going to half to get one from ptp.

[Daniel Morse]

Also interested

Tom, can you help us out with this. I would like to have these spare parts for the warp so I can replace them if they go down. If Radio Shack sells the motor what is the exact model #? Can I call up for the board, belt, and sensor?

[Potatoboy]

I called last week and talked to Marcia about replacement shells, she said they were $25 bucks for each half and they were running low on some of the colors. At least I think it was Marcia, if not, my apologies to JoAnn.

[ah137]

If you go to radio shack you can't miss them

270-256 9-18 volt motor
273-255 12 volot motor

I am not sure which one comes stock? AGD will have to tell us. Which brings me to another question. Why you can't use the emag battery to power the warp. Is it because the motor burns out. Or is it because of the voltage limitation of the board. If the motor is the problems couldn't you just put a 9-18 motor in it? Tom could you please answer this question, when you get a chance.

later

[ah137]

Tom, you out there?

Thanks

[AGD]

I am here, the two motors from Radio Shack are basically the same. You can probably use either one. Yes we will sell you the PC board for the Warp and you should get some extra contact springs too.

The board will fry with 18 volts because the transistors and capacitors are not rated that high.

AGD

[Muzikman]

The question I have is this...

If you used the 18V battery in the emag so you can run all your battery powered devices (warps and Loaders) off the battery. Why did you leave no way to plug them in?