can anyone take a pic of an eggo on a ULE. I just want to see it and how it looks. color doesnt matter.
-
Yummy yummy yummy, I've got fun in my tummy.
-
It works nice, although the balance of a small mag and any hoppper just feeels weird, specially considering the egg weighed about the same as my mag, muahahahaha.
2 da k da 2 Timmah.
Oh..it shoots da 620:1 .No problemo. -
when i had one i got soooo many hopper shots on it, from being so high
My Feedback
Not Wearing Pants Since 1999
President of The Anti-Pants Party
Join The Anti-Pants PartyComment
-
-
I didnt like the way it felt on top of my mag
Props to echo419 for the sigComment
-
yea but the whole plastic piece didnt feel real stable to me, it seemed like if you cut it, it would lose some stabilityOriginally posted by SpongeBobSquarePants
sps-Cut it.
My Feedback
Not Wearing Pants Since 1999
President of The Anti-Pants Party
Join The Anti-Pants PartyComment
-
on my mech
My Feedback
Not Wearing Pants Since 1999
President of The Anti-Pants Party
Join The Anti-Pants PartyComment
-
on emag
My Feedback
Not Wearing Pants Since 1999
President of The Anti-Pants Party
Join The Anti-Pants PartyComment
-
revvy or egg2 on a mech mag with xvalve and ULE? i dont know if the revvy could keep up, and i dont wanna spend the money for a halo. opinions?Yummy yummy yummy, I've got fun in my tummy.
Comment
-
i have a halo now, and that thing is awesome. Personally the egg i had was a piece of junk it broke on me a handfull of times and got me nothing but hopper hits. If price is an issue just look for a used halo, other wise i would duely suggest the halo
My Feedback
Not Wearing Pants Since 1999
President of The Anti-Pants Party
Join The Anti-Pants PartyComment
-
Insert the Egg into the feed neck and then take a sharpie and draw around the neck onto the plastic. Now, take a dremel and cut along that line and shorten up the feed tube a bit. It will sit really nice and feed fine if you do a good job cutting it.
HALO's have their problems too. I've seen the new backplate design on/off buttons break, transistors pop off the board, feed cone screws back out and fall off, motors burn up, etc.
Eggs aren't much better, but they're cheaper and feed well enough for most guns.Comment
-
I'm going go out on a limb and suggest a Reloader.
I have one on my ULE E-mag and it keeps up fine(of course, I don't have 3.0 yet so that's going to change 
).
Comment
-
... Maybe a HALO TSA?Comment
Comment