My Revolution sucks

[bunkermaster10]

Yep they SUCK. My friend bought a new smoke one and was showing it to me and I opened the lid for like one of the first times and it just shattered.

[tony3]

I have owned an eggy, halo b, and a revvy. I have switched back to the revvy because its so light, and feeds fast enough for me, I only shoot in bursts anyways. And its so much lighter then a halo or eggy. Not to mention the great balance of it

[Mr.Minus]

where can i buy all the x-board internals....motor + board and everything , plus one of those better 6 leg paddles so i can stick it all into a pre be shell...??? any dealers have that stuff, or would it just be easier to buy a brand revee and switch the shells?

thanks

[Sir_Brass]

I boughty my 12v revvy with x-board in april and it has yet to show any signs of wear. It's still on it's first set of batteries and the low battery indicator hasn't come on yet, it's taken many hits from paintballs and not cracked at all, and the lid is in excellent condition.

I don't see what people are saying about 'pre-BE' and 'post-BE'. all that 'post-BE sucks' is bs. yeah, they had a bad run of shells. that was one bad run. they corrected the problem and the shells for the revvy are just as strong as pre-BE. Then again, I use a black revvy, and they may only use crap translucent plastic in those, while they might use that reinforced black plastic in the black revvies (the same black plastic used in the stingrayIIs. that stuff was indestructable. it was the translucent plastic that sucked balls).

[RenagadeOfFunk]

I have my X-board revy up for sale...It intelled and ready to go...it works fine its Half red and half black...I just couldn't use my dye 03 stickys with the wire coming out of the grip...its for sale...check the misc. items section...IT WORKS GREAT....but for me the time is HALO!