Pump kit rail and rods, anyone ever get them made?

[cledford]

Being one of the people who bought a pump kit a few months back I was quite pleasantly surprised to discover (while cleaning out the parts bin) that I own one of the pump kit main-bodies. It's a mini with the enlarged sear hole, and the slot for the pump rod.

To finish out the gun I need a rail with the slot for the pump rod, and the rod itself.

Someone a while back was talking about getting the specs for the rod from AGD and having a custom run dome up at a machinist - did anyone ever run with it?

Also, does anyone know where to locate a rail with the slot? I'm willing to buy one, or I have a post in the classified section with an ANS "Cut and Carved" main body rail for trade.

Anyone ever get the pump kit up and running?

-Calvin

[Hexis]

I found somone with a complete kit. They are going to send me measurements of the pump rod. I should be able to make one from that. It would be a lot easier to just get the measurements form AGD, but so far any request that has anything to do with measurements has been flat out ignored.

It looks fairly simple. Three bends total. Just need a couple measurements and the one angle that's not 90.

[the123]

I still need a Rod myself. However I located a brand new Frame rails with the groove milled into it. You'll have to call the people at www.justpaintball.com and talk to someone about what you need.I think I bought mine for $20 or $25. We WERE waiting on MUZIKMAN to get the rods for us. He must just be too busy