Ok, so here is the deal, i just purchased a used flex-7 and it is awesome, works perfect, etc, any, the only thing wrong is that during shipping they didn't keep, this side up^ so it fell on the flexible part and it is now bent under on the ride side, does any one have a suggestion to fix it?
-
Whenever my mother decides to store my mask while I'm at college, the flex always ends up being bent. I recommend stretching the flex to its original position and leaving it sitting on a table with enough pressure to reform it back. Leave it over a few nights, and it should be just fine =) -
Did it come with the cardboard cutout for the flex part? If not, you can easily cut one out and fold it to match the corners of the flex part. I hold mine in place and shape it with bobby pins and put it under the blow dyer. After it gets real hot, I switch it to cool air. Then, I let it sit there for a few hours. It always goes back to its original shape.Comment
-
-
Just hang it from a line and let gravity work to your advantage
Comment
Comment