hehe,I just got a ult and it says if i need to add shims unscrew it,but it wont unscrew just keeps turning?what am i doing wrong?any help is greatly appreciated :)
-
http://www.automags.org/forums/showthread.php?t=126801 -
Pull and unscrew. There is some play before the screw engages. I had this same problem, oops.Down with Righty! -
One other thing: The unscrewing motion might get a little tight, but keep going. Be careful about it, and it'll come right off.Comment
-
be careful! make sure when you DO get it off, that you pull straight up and not bend the rod, cause if you bend the rod, you are screwed! and i think that AGD will not warrenty that??
04 Dust Grey Immortal Viking # B 01529 :headbang:
You mess with me, you mess with Bad_knees :DComment
-
should i throw some oil on the o rings before reinstalling?http://www.automags.org/forums/showthread.php?t=126801Comment
-
yup! that would be a good idea
04 Dust Grey Immortal Viking # B 01529 :headbang:
You mess with me, you mess with Bad_knees :DComment
-
hehe i just wanna be sure thnx all for the help
http://www.automags.org/forums/showthread.php?t=126801Comment
-
no problem bro! good luck with the ULT, i have one and its great! if you tune it just right you can get it the trigger to walk, I have yet to get there
04 Dust Grey Immortal Viking # B 01529 :headbang:
You mess with me, you mess with Bad_knees :DComment
-
little late but oil the hell outta them, and see what wonders it will doComment
-
like mag amster said... DRENCH them in oil
Proud Member Of The AO Cesspool Since 08-24-2002Comment
Comment