Question for all the Morlock Owners

[xrancid_milkx]

I have a Morlock Board in my E-Mag and so far its been great, but I have a question relating to adjusting the ROF.

Other than just stright up changing the ROF cap (6 clicks, 3 clicks, then whatever ms you want [x]/1000 = your BPS), is there something else I need to do or adjust, like the solenoid timing and what not?

I have read a few threads about messing with the solenoid pulses and timing and what not to help with the ROF and I have no idea how to do this or even if its needed.

So a little help?

[redlaser666]

The solenoid on time for an e-mag shoud be 20-30 ms long. this time must be added to your ROF timer to get the total.
Ej. 25ms solenoid time + 25ms ROF = 50ms total (20 bps)

One question for you: how is the hall sensor connected to the morlock? what color goes to what pin in the morlock?

Later,
Raul

[xrancid_milkx]

I got my E-Mag in a trade with the board already installed so I have no idea

[sniper1rfa]

do this:

3 clicks, 3 clicks, 25 clicks, 6 clicks, 3 clicks, 25 clicks

thats 20 bps. Add or subtract from the rof holdoff (6 clicks) to increase (subtract) rof, or decrease (add) rof. Add your rof holdoff (the six clicks) to 25, then divide by 1000 to calculate maximum rof. (eg: 25+25 = 50, 50/1000 = 20)


Do not change the solenoid one pulse. 25 is the minimum length required (well, not really, but anything less is not guarunteed to be safe. You cant pull 25 bps anyway.