Trigger Stops for ULT?

[CoolHand]

Originally posted by SpecialBlend2786


me too. That would make things infinitly easier.

You guys should look into some ball ended hex keys.

They won't make a hole appear in your frame , but they will make it much easier to put that screw in without one.

You can buy a combo set of both metric and standard sizes from Enco ( www.use-enco.com ) for like $8 or $10 (made by Allen too, so they are good quality).

Later

[SpecialBlend2786]

oh nice, thanks Coolhand

[Aegis]

Originally posted by Bad_Dog
Adjusting it to the proper length takes a little while though. Too long and you could chip the sear or round over the edge of the bolt. Too short and you defeat the purpose for having the stop...

thats my $0.02

Good point, I am a bit concerned about that as well. How did you decide where to draw the line? I am thinking adjust it in until it will fire, then give it another 1/4 turn or so for clearance.

[greg]

.... collhands... when do u think that trigger will be ready for the intelliframe???? put me on the list when it is
...cause i want one

[Bad_Dog]

How did you decide where to draw the line?

lol, I didnt... I discovered the results when I took my mag apart and the edge of the bolt was round but it's all good...
(that just means that I had to back the set screw out a little further than I would have had to before)

[JEDI]

Originally posted by Bad_Dog
lol, I didnt... I discovered the results when I took my mag apart and the edge of the bolt was round but it's all good...
(that just means that I had to back the set screw out a little further than I would have had to before)

Mind explaining how either of these is a result of too long of a stop? I dont get the connection.

[Bad_Dog]

It was from having the stop too long; which means that the sear just barely nipped the edge of the bolt... causing it to chip away.

[CoolHand]

Originally posted by greg
.... collhands... when do u think that trigger will be ready for the intelliframe???? put me on the list when it is
...cause i want one

Its not a big redesign, so I'm thinking sometime in the first part of January probably.

I've got to sneek some V2 Imp frames in there somewhere as well, to take to Kickn' with me.

Been real busy.

I will post here on AO when they are ready.

Merry Chistmas all.

[greg]

amazing...... you smart people... ill be the first on the list in january.... waht u think the price range will be??? is it gunna be just like the trigger on the vert frame????

[sneakyhacker420]

Originally posted by rikkter



i hope you weren't referring that pic to a trigger stop. thats the trigger rod.

but if you're trying to show what kind of trigger would NEED one, that picture is perfect lol

idiot...

[personman]

y does cristmas suck

[sneakyhacker420]

dont mind me... x-mas sucked for me... and still is if you wanna get technical