AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026.
Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
On my emag, I run the stainless steel hose forward and next to the battery. I have a keychain ring through the pin and around the hose. When I take out the pin, I just let the keychain ring hang down at the bottom until it's time to put the pin back in. Works great for me.
I have mine on a very small split ring, and on that small "dog tag" ball chain. I run the macroline thru the chain. I use to have mine on a leash from a HPA dust cap nipple attached to the macroline.
I don't keep one in with the X mag at the moment as I just use the switch on it right now... but in the past I always kept a plastic coil leash like one you would put on your fill nipple to keep up with it. I would attach it to the air line (the ring that normaly attches to the nipple can be put through Macro or even SS line if you open it up some) and let it dangle there when not in use. I have also used the ring part of a key ring and strung it on the air line too and let it dangle down when not in use.
AGD, where we are so good we can do it with only ONE tube!
I had a small keyring through the yellow pin, a black little springy curly cord, then a small washer that I put over the hole in battery back. Then, I screw on the field strip screw so it gets held in place right near the hole for the yellow pin, and also is very well in place.
Comment