Newer Software??? 4.0???

[Evil1]

When will this be available if it isn't already?

[felony]

yikes assembly..

ive done c++ and am doing C right now, so PROPS to you!

anywho, if tom hit 26 bps, legally.. holy shiza. didnt think that was possible with the 1 pupll 1 shot deal, but hey what do i know.. obviously littl

dan

[RoadDawg]

This flash of right now is in a huge beta test mode. Basically we are the test subjects. Final version is still to be released. Til then good luck getting it.

[Miscue]

Originally posted by felony
yikes assembly..

ive done c++ and am doing C right now, so PROPS to you!

anywho, if tom hit 26 bps, legally.. holy shiza. didnt think that was possible with the 1 pupll 1 shot deal, but hey what do i know.. obviously littl

dan

He wasn't hitting 26, more like 20. No marker was exceeding that to my knowledge... we'll be looking into that, as all of this is new to us.

[felony]

sounds good.. keep the info coming.. im loving it..


dan

[OfficerGoat]

We need to get one of these over a chrono that will do shots per second. I am sure one of the local gun shops has one.

[sps16]

the software is really fast, i can hit 20-24 on the bps counter.
Hey miscue, when my battery starts to get low, it starts missing shots on each pull and be able to sweet spot in on knight rider mode

[Miscue]

Originally posted by sps16
the software is really fast, i can hit 20-24 on the bps counter.
Hey miscue, when my battery starts to get low, it starts missing shots on each pull and be able to sweet spot in on knight rider mode

Ok, what this is... is:

When the battery is almost dead, the solenoid steals power from the HES and makes it turn off even if you have the trigger pulled. The solenoid is powered off, HES gets power again... and it behaves like its in runaway. A brown-out condition, basically.

This is normal... and all the software did this but you didn't know it. Your battery is too low to even get close to firing when this condition occurs. Charge your battery!

[sps16]

awww ok

[hitech]

No offence, but are you sure the ROF meter is accurate? I turned off the solenoid to insure I wasn’t getting any “bounce” and I was able to hit 20bps a few times and could “easily” and consistently hit 18bps raking the trigger. This is really only the second time I’ve tried raking the trigger. My trigger isn’t all that short or light. It’s hard to imagine that I am that fast.

BTW, I was also able to hit 7bps just pulling the trigger “normally” with my index finger.

[-=Squid=-]

miscue - why dont you develope WAS type boards for other markers? You could make a killing...

[Miscue]

Here's the deal on the accuracy:

If it says X bps, the board tried to fire at X bps. The thing is, the board does not know if your marker actually fired. If the mechanics are keeping up with the board, then it is accurate.

We've noticed that somewhere over 20bps, the plunger stutters and does not get a full stroke... misfiring. We're looking into this.

It should have no issue at 20bps though, to my knowledge... However, your gun needs to be well tuned. We had a marker that had the plunger length adjusted wrong, and it couldn't hang at all. Also, need a good tank. We had an 850psi preset that wasn't outputting 850 (pre-sets often do not output what they are rated to). And, the input pressure is used to kick the solenoid plunger back into place. Increasing input pressure will kick it back harder.

But once again, these issues are brand new to us (hence the beta test)... and we're working on better understanding what is going on with it.

So... hope that answers the question. Electronically it is is 100% accurate. The issue is whether the mechanics are doing what the electronics want it to.

Edit: 99.x % accurate, because w/o an RTC and quartz crystal situation... the internal timers are not perfect, but close enough.

[Miscue]

Originally posted by -=Squid=-
miscue - why dont you develope WAS type boards for other markers? You could make a killing...

Lack of interest. There are other projects I'd rather be working on. And I don't quite see how I could make a "killing."

[-=Squid=-]

Originally posted by Miscue


Lack of interest. There are other projects I'd rather be working on. And I don't quite see how I could make a "killing."

Ok im sorry, I am completely wrong and will never direct a question to you again.

[RRfireblade]

Originally posted by Miscue
. Electronically it is is 100% accurate. The issue is whether the mechanics are doing what the electronics want it to.

I'm still a little skeptical that all of a sudden,everyones pulling 20+ bps when I've never seen anybody pull that fast ever,on any gun w/ a legal bounce setting.I kinda though 20+bps was hard to do.