E/X-Mag 4.0 software, update?

Collapse
X
Collapse
 
  • Page of 6
  • Time
  • Show
Clear All
new posts
Previous 1 2 3 4 5 6 template Next
  • trevorjk
    <S>WooLooLoo</S>
    • Dec 2002
    • 4324
    #76
    Re: Re: HES problem poss solution

    Originally posted by hitech


    Can someone tell me how to turn the magnet around? And if soldering is not a problem, which is easier?

    he said no soldering was needed so im guessing you dont have to solder anything
    t33kyboy "So if a cat is dropped from 11 inches, it will most likely die."

      Comment

      • Swede X-mag
        Registered User
        • Jun 2003
        • 19
        #77
        Re: HES problem poss solution

        Originally posted by John Sosta, AGD Europe
        The full auto issue can can resolved by turning the hall sensor around in the carier by 180 degrees you will also have to turn the magnet around as the magnet will be the wrong polarity after the turning of the hall sensor .
        This has worked for us in 12 cases of the the full auto issue, Those of you that are having this problem should try it it involves no soldering and takes about 5 mins.
        I did this last night and no more trigger bounce for me.

        But Then I only have 2.21 on my board. But the full auto is totaly gone.

          Comment

          Previous 1 2 3 4 5 6 template Next
          Working...