Hey Butter, if you don't mind my asking, where did you get your hands on a dentist drill or handpiece? Do they just run off of a compressor? How much psi do they run on? Whenever I went to the dentist office and he left the room, I always wanted to play with the drill and start drilling stuff.
-
-
Yeah, they run off an oil free dental compressor. They usually will run 400,000 RPM @ 32psi. Although not reccomended, faster at higher pressures.
Here at school they provide you will all that stuff...Last edited by Butterfingers; 03-19-2004, 03:57 PM.Did you hear about the new european weapons contracts? France is going to make the wooden sticks Spain making the little white flags
Comment
-
Another person trying the sear mod... I love it
Feedback: http://www.automags.org/forums/showt...hreadid=105565
Feedback on EBAY under QUINCYMASSGUY
Good traders: paintcatcher, a few othersComment
-
Nice burr. I personaly use PC board carbide drills, good for up to 50,000RPM although i run mine in the 1000 - 6000 rpm range.Comment
-
You are going to school to become a dentist? Will you get in trouble if you break your drill?Comment
-
Probably...
Or...Ill pull one of these...
Me: "Hey Roger I think the handpeice you issued me is defective... do you concur"
Roger: "Hmm how did that happen..."
Me: "I dunno it just stopped working, you know these things are older than me"
Roger: "Ok don't break this one"
Or somthing like that...
I didnt use the handpeice for the Sear work I put the bur in a drill press and it cut.
I did however use a handpeice to mill a grove in my automag rail... It didnt work too well the aluminum is too soft it clogs up the flutes WAY too fast.Did you hear about the new european weapons contracts? France is going to make the wooden sticks Spain making the little white flagsComment
-
How much do the burrs go for?Comment
-
if you buy a 50 pack they are about 98 cents each.Did you hear about the new european weapons contracts? France is going to make the wooden sticks Spain making the little white flagsComment
Comment