I am looking to mill my LED Trix in the near future, and would like any input as to what would look cool. I can mill all the way through the body in the areas between the black lines (in the pic below). Any where else i can mill, but it would not go all the way through.
I have some ideas, and am looking for more ideas from all you creative minds out there
\/ I can mill all the way through between the front two lines, and the back two lines and its white because i have a piece of paper covering it so i can draw ideas...\/
I have some ideas, and am looking for more ideas from all you creative minds out there
\/ I can mill all the way through between the front two lines, and the back two lines and its white because i have a piece of paper covering it so i can draw ideas...\/
