If the agitator in the revvy continues to spin with paint in the neck, does that mean the sensor eye is bad? Also, are the sensor eyes easily found at Radio Shack or some other electronics store. Thanks for the help guys.
-
-
you screwed up the wiring on your board is what it sounds likelevel 7 pf automag
aci gas-thru foregrip
benchmark vertical adapter
armson stealth 13"
benchmark double trig frame
47ci flatline
12v xboard revvy -
I haven't messed with any wiring, it just started doing this. Thanks for your input though.
Comment
-
You might have paint (the liquid, not the ball) in your feedneck. Simplest thing to first do is clean out the feedneck. Any chance you had a chop the last time you played? Paint might have been blown up into the neck and is covering the eye.Comment
-
Well, if paint is covering the eye then the revvy WONT spin your paddles. The eye waits for a gap in the ball stack before spinning the paddles, so if the eye is covered, it cannot sense the gaps and wont do anything. It basically thinks that there are balls in the neck.Originally posted by deathstalker
..............i think :oComment
-
rust on the circuit board will do this also, a connection may be shorted.Comment
-
-
I used to have a clear revy, everytime i was in sun light it would spin nonstop. I had to finally use something to cover it up.Team Red Demons, sponsored by Rex Plex, National Paintball Supply, Shooters & looters, & wildwood paintball + more coming soon!
Vote Now! (Get me off AO)
My ebay Feedback
Comment
-
Same here. i just covered the feedneck with tape and it worked fine after that......intill someone shot it and it brokeOriginally posted by 1ofkind
Comment
Comment