Need updated on lvl 10 , alum mainbodies , air efficentcy ,ect

[Nitroduck]

OK....its been about 3 years since i've messed with mags much but i just ordered a new tac-one. Cuz of that i got a few questions.

How does level 10 come set from the factory ? Can i continue to use the cheap crap paint i've been running through my other guns?

Are the tac one bodies much lighter than the old SS bodies (i've only used em )

How different are X valves versus old RT valves , i know they're alot lighter but didn't know any more than that.

What's the air efficientcy of a xvalved mag with the stock JnJ 2 piece ? I've been getting 1500 off a 68/45 and don't know if i'll get significantly lower than that , lil less or the same , what's the average efficientcy?

I know recharge is higher on RT baised valves than classics , but how about FPS vairance ? My mag used to get +/- 1 with a mark3 tank so i don't know if i'll get really good consistantcy or not.

Will my 12v xboard rev with impeller work well with the gun or will i need a new one?

What shout the output on my tank be ? I've been using a ajustable output maxattack and they're hard to get higher than 600psi.

It'll be nice to try one of the inteliframes.....i had one of the prototypes back in the day cuz of the first contest AGD ran..........i had to sell due to money issues and now i can get one now so.........

[pointm@n]

You may have to tune the LX a bit from the factory.

Tac1 bodies are pretty much the same weight of a SS body I think. I had a ULE body and swapped it for a Tac1 and it's considerabley heavier than the ULE. I don't have a SS body to compare, but the Tac is a pig.

You'll need another tank. 600psi going into the xvalve isn't going to cut it.

You may need a new hopper. I don't know how fast you can shoot, but I could outshoot my Reloader (pretty much a revy, just sound activated)

[Nitroduck]

Any other opinnions?

[mobius]

The level 10 may need minor adjustments, but it'll likely be just fine.

X valve is simply an aluminum Retro valve. No other differences to speak of.

On a 68/4500, expect 1000-1200 rounds.

Your Revvy will prolly be fine.

You want at least 700 psi, if not 800 or more with an X-valve.

And yeah, the Intelli's are nice.