Awsome Idea (for those to cheap to buy an e-mag)

[Chipper]

Hope this is not old, I never noticed it on AO....

Saw this searching PBreview for no reason.

Tight, huh?

Is this at all possible? Do yall have any ideas on how its done? I have no $ for and e-mag, not even a hyperframe, so this is like !dreamy!

[EverlastPaintball]

It is possible.........I dont know how to do it though

[paintballrulzs]

I owned a hyperframe and loved it. This does make me very curious though. I can't see it being done without major modifications. If those modifications are dont wrong it could ruin the frame or even the gun . I say just buy a used hyperframe for like 150 if you really wanted one. This would also have no warranty with any company. If you buy a hyperframe you have some piece of mind knowing that centerflag has your back. I am curious on how he modified though.

[GT]

Honestly there the same design, same type of selanoid. My hunch is that with a ULT installed you could get fairly long battery life

[ANGEL LCD]

if it worked really good i might get a mag just to do that

[Glickman]

woah..
i would imagine the only difference would be the sear, and that could be customized pretty easily


theres alot of experimenting to be done with different marker compodents, cause after all, alot of guns are just based of others
ie.
More Clones
Spyder Clone
Spyder
Timmy
Timmy Clones

[shivors]

On top of that you could get a new board for the frame and increase cap and mount ACE on it.

[tony3]

My guess is that he is a ult and then mount the sear somehow, interesting idea...

[Glickman]

that board says nothing about a unlimited cap, atleast not what i can see. i have seen alot of upgrades and custom mods for that frame tho, like a new switch for like $5 from r@dioshak that has a required pressure to activate less then that of an angel (0.02 lbs maybe?)

but with a level 10, i dont see a real need for eyes other than the fact that they get dirty, hard to clean, but then again its like a safe withen a safe

[ZapTheMad]

It wouldn't be hard to do this if you have the right tools. If you look closely, the solenoid is turned around backwards in the frame. That is the only way it could be done because the stock frame has the solenoid pushing forward which goes the wrong way for use in a mag.

Hmmm, I may give this a try. I have a couple extra spyder electro frames handy. One is a dragun LCD that does 20 bps! I also have a small machine shop set up in my garage :)

I just held a rail and a spyder frame up together. It doesn't look to be all that hard of a mod. The stock sear lines up pretty well and would need minimal modification.

Something is cool brewing up in the madhouse!!!

[tony3]

but with a level 10, i dont see a real need for eyes other than the fact that they get dirty, hard to clean, but then again its like a safe withen a safe

What about lvl 10? Brings down efficency, can be picky, leaks sometimes, my lvl 10 leaked quite a bit.

[Glickman]

heh, i was just assuming (yes, im making an *** out of "u" and "me") that it would be in working condition

[ilikePB]

If someone could do this it would basically be a cheap way to do a Devilmag, you could make a little extra cash for doing the mod for someone else too. Sounds like a good idea to me.

[hitech]

How much is that frame?

[spasticsquirrel]

i think that the frame would be like $85 online maybe?