Evolution 2

[Snowball]

Could anyone tell me if i cut down the evo feedneck would it mess anything up with the eye inside or should i just cut atleast one ball length...thanks

[coolcatpete]

No you should be fine. Most people cut theirs.
Pete

[Adrenaline_Junkie]

It works fine. I did it to my evo so it would fit lower on my ULE body.

[Halliday]

I bought mine used and cut. It works great.

[Kevmaster]

make sure you do leave enough so that it fits into the feedneck...but you don't need to leave anymore than it takes to fit in snugly

[Skoad]

nice thing is if you mess it up, you can always buy new tray/neck pieces.

[mark_426]

i have about 13/16ths coming out of the egg, measuring from the lip on the raceway.

With it, my Z-board still works fine. The eye is well up into the outer shells, they are on the same plane as the board is (all one piece).

If I remember right, someone said it decreases the speed or something, but I dont think you can shoot 5 shots before the egg reacts. (it's bs)

[m20power]

i have about 13/16ths coming out of the egg, measuring from the lip on the raceway.

With it, my Z-board still works fine. The eye is well up into the outer shells, they are on the same plane as the board is (all one piece).

If I remember right, someone said it decreases the speed or something, but I dont think you can shoot 5 shots before the egg reacts. (it's bs)

My problem with the Evo was those first 5 balls would not feed at 17 a second. They are not being forced down so all they have is gravity working on them which is 13 a second I belive.
When I would get on my angel from a dead stop I would get chops. I had to go slow and then work my speed up.
I tested my hopper and with the barreries I had in it I was getting 15 a second. Not good since I have peaked my angel at 17.

[Snowball]

cool..thanks for the info guys..i think i am gonna cut it down a bit...thanks alot

[i_baked_cookies]

what did all of you cut it with?

[mark_426]

what did all of you cut it with?

I used a PVC pipe cutter, like this:

You could also get a nice, even cut with a normal clamp-on pipe cutter, such as:

If you dont have that, I'd assume you could do alright with a coping saw or a hacksaw, but make sure you dont snap/crack the rest of the neck. Also deburr the inside so there is no place to catch when attempting to feed, either with a utility blade or a round file.

[JimmyBeam]

a dremel