Anyone see a problem in cutting a warp ule neck

[Magglerock]

I want to cut my warp ule neck to get a closer profile. Anyone see a problem doing this?

[Blazestorm]

I wouldn't recommend it

But don't see a problem, can always buy a new one if it doesn't work... Rogue has them for 10 bucks I believe

[Enemy]

um i think he is reffering to the ule warp body.. i wouldnt recomend it cuz the side of the gun it is on should never be that exposed!!!

[sneakyhacker420]

if you do cut it, make sure you use a pipe cutter (so you get a uniform cut) and take a file or dremel and chamfer the inner edge so that the balls roll in nicely

[FreakBaller12]

I wouldn't recommend it. Why ruin a good thing? Y6ou got a $150 body and why are you gonna cut it up, why risk ruining it. What for like less than an inch? I personally wouldn't risk it, not with $150 piece of allumninum.

[nospmas311]

how about on a pf...

I just got a warp and I have a pf/hl body. The 90* adapter makes it big...what about cutting the pf down? Is there a problem with that and how do you do it...

thanks.

[Blazestorm]

Take a pipe cutter to the tube, measure properly so it sits low. cut above your measurements then file it down, watch the inside too

[FreakBaller12]

or u can buy a 45* bad dog elbow,
check the dealers section.

[AGDlover]

i would not recamend it at all unless you have one of thoughs bad dog 90* warp elbows. if ya don't then don't cut ti AGD's elbows sit all the way back on them so it wouln't do you much good.

[Bad_Dog]

are you referring to the actual infeed tube? where the warp elbow connects to the body?

if you shorten the tube, do you plan on bringing your loader closer to the side of your marker? because thats what'll happen, unless you cut the tube and just run the warp elbow closer, but then technically you wouldnt be getting any tighter of a setup...???....

I just dont see the reasoning behind it...

[nospmas311]

Well...

now i'm confused as who is takling to who...with my powerfeed body, cutting it will definately help...with his ULE...forget it.

Also, why forget it with the 90* from AGD...it will still be closer to being on top of the gun then way out.,