snatch grip

[coolcatpete]

why not just make one?

Because I am incompitent and bad at making things with metal.
Pete

[bleachit]

good enough, I guess.

[coolcatpete]

However if anyone want to make me one I would pay for one becasue it makes your gun super AGG.
Pete

[OysterBoy]

Mine wasn't very pretty, but it did just fine; I took an angeled PMI ASA ( a flat duckbill would work) and widened the holes in the back of the rail, then sunk the holes in so the screws would be flush with the rail. Then I just used some nuts under the asa to hold it in place, looked pretty nice.

[The Frymarker]

I have a question about these, that maybe you could answer, do you think resin would work well as a snatch grip???


I was thinking of the pewter route but just wanted to know.

[OysterBoy]

If your asking me, I'd say anything stronger then the same grade plastic used in the common revy (new). This is an estimate, but it doesn't take much abuse so it should hold up. In terms of looks/flow, Resin would probably look a little nicer. Either or.

Unless you weren't talking to me, which wouldnt be a surprise.

[The Frymarker]

I was asking anyone who wants to answer

I was thinking the transparent resin would look neat as well and would weight less


Hmmmmmm

[elpimpo]

whenever someone says resin i never think of the plasticy stuff