sticky grips ???

[hubadlatimmy]

I got my 2002 stock vert feed cocker today and i got dye sticky grips with it and they are just a bit small and hard to put on so I was just wondering if anybody knows any little tips on how to get these things on I have 3 screws in but the 4th is just impossible.

[pito189]

I got the same thing you did, but I didn't get the stickies i'm waiting till I get a hinge trigger. Keep it posted if you figure out how to make them fit.

[hubadlatimmy]

ugggh...

The gun and everything is great it is being a poopy-head to get the grips on and I gored my thumb and pointer finger on my pump rod and push pin.

[magman007]

wh of trigger frame do you have? if the wrap arounds dont fit, try gettin some stickey panels, there cool. te stickies may just not fit! also try boilin em for a few secs then pul em around

[hubadlatimmy]

YAY

Well the grips are really tough and i figured that out but the way to do it is to put in the bottom screws first then the top right and then top left. It is much easier to say than it actually is, I got them on by pulling on the corner like a madman and pushing it towards the screw hole at the same time.

[ronron2112]

i had this problem with my friends tippmann

what we did was one pulled it, and the other screwed it (no pun intended) we also tried startting the screws from different points. finaly when we got it to fit, it fits great now, nice and snug, and no tension. good luck!

EDIT: i didnt read the post that said you did it, sorry

[DYE-BaLLeR]

same with my friends impy

[RaV3n_Pa1ntba||]

or if anyone ever played any other sport before besides paintball (well who would wanna) you could mold em (eX: Mouthguard) .....heat up the stickies have your gun and screws and screw driver ready.....then quickly after the water is boiled take out the stickys dry them off......and strech them around the grip frame. And yes is alot harder than it sounds.