After taking out the bolt and reoiling it he put everything back together. When he put the compressed air system on (68ci 3000psi bulldog 3) the gun started leaking enormous amounts of air out the barrel then when he further screwed in the tank the leak out the barrel stopped and came out the asa. He had about 950 psi in the tank and quickly dropped down to 400. ANy help would be appreciated.
-
-
Sounds like he didn't cock it before he pressurized it. As for out the ASA, probably just a blown o-ring.Hey, look at that! It's Santa!
-
""Originally posted by WenULiVeUdiEComment
-
after checking the oring on the compressed air system the oring looked totally fine, the gun stopped leaking out the barrel though.Comment
-
if the tank was low on air dont know if the guage on your nitro was broke but it sounds like the tank was low on air, and maybe you didnt cock the gun? or somethings wrong with your valveOriginally posted by punkncatComment
-
hmmm it could just be low on air, but i cocked it myself and put the tank back on which had about 300psi didnt leak throughout the barrel but out the asa. thanks for your help.Comment
-
Check your macro or steel braided connections. It's the only thing I can think of. Tighten it all up and then submerge it in water. When you put it in water, the leak will cause bubbles. This will show you where the leak is, and if it is still there.Hey, look at that! It's Santa!
Comment
Comment