pure energy low pressure spring pack

[fire1811]

anyone know where i could get one of these?

some where you know they are in stock would be appriciated.

thanks
curt

[soccer4minimags]

For the tank reg or their inline reg?

For the tank as far as I know the bevel washers controll pressure. You lower or increase it by adding or removing them. They come in a parts kit that I have only seen sold directly through PMI. Basically it was enough parts to completely rebuild your tank reg, including an extra set of washers.

[fire1811]

its for the tank reg
it replaces the spring pack

[soccer4minimags]

edited above post

[fire1811]

so is it safe to remove some of them?

just called pmi and they have the low pressure kit but they cant sell it directly

[soccer4minimags]

why do you want to lower the output on your pre-set anyways? Are you trying to by-pass an inline reg?

Take your reg apart and look. You make the call. I havent done it myself. I have taken it appart many times though cleaning out stuck pin valves.

I cant really see any danger in this, anything you do is after the burst disks. Call a pmi tech and ask them what exactly you should do.

[fire1811]

i need to lower it for my angel speed.
you are supposed to input 4-500psi into the minireg.

i am inputting 850psi right now and with the minireg mod(flipping/removing spring stacks)
i can only get my velocity to 298fps. thats too close to the limit.

either way i found a site that has these in stock and ordered one. it will bring the preset down to 480-500psi depending on how i set it up.

so basically for $26 i now have a fixed low pressure and high pressure tank.