Warp feed issue

[botchio]

I have a warp feeed hooked up to my minimag, i have intelifeeded the warp to save batteries, and im just wondering if theres a way to solve the ball swelling problem? when my balls swell they dont fit into the breach, causing the gun to not be capable of shooting as fast. i have to sit there and push them into the breach with my fingers. any help would be appreciated. I had an idea of cuting the breach wider, but let me know about your ideas

thanks

[Chronobreak]

so they go through the hose and the warp adn elbow fine but wont go into the breech?

[botchio]

yes, i have to push them into the breach threw the feedneck whole

[Chronobreak]

what type of feedneck>? and paint? is it overly humid there?

[botchio]

ususaly huricane paint, and its not really a feedneck, its like the tuby thing the right feed part of the minimag, i stuck my hosing for the warp right onto the left side of it, it sticks fine and stuff, and it is meh humid here, i live in hamilton

[botchio]

if you have any good ideas and msn, either post here or add me to msn [email protected] i dont have aim unfortunetly

[botchio]

im gone for the night, talk to you laters

[TheTramp]

Have you tried to let a ball drop through that part of the feed without having the Warp hose on?

It could be that your Warp isn't pushing the balls hard enough to get them over that last hump.

This could be because of low batteries or an loose drive belt (big black o-ring).

If the paint wont go through the feed even when just dropping it from above, then basicly you should either get some new higher quality paint or try dehydrating it a bit.

You can dehydrate your paint be putting it in a single layer in a brown paper bag for a couple of days. The paper will absorb some of the moisture.

[botchio]

ok thanks for the idea i will try dehydrating, but it was full batteries, and i put the paint in the feeneck without the warp hoses and it fit fine...but ill try dehydrating, and the hurricane paint is pretty high grade, im usualy using evil tho wich does work better.

[TheTramp]

You might want to look at one more thing. It could be that the discs aren't gripping the balls very well and are slipping before they should.


Here's a question, when the Warp is trying to get the balls into the feed neck, are the rubber discs sliding past the balls in the warp or do they stop?

[botchio]

the rubber disks slide across the balls, they dont stop