Ok I did a forum search, scoured for many a minute, and could find nothing. WHY DOESNT BANANA MAN DANCE ANYMORE??? This is a travesty, a sacrilege of magnificent proportions? Why????? Is it just my computer? I doubt it is because all the other icons are still rocking 
...
And secondly, for those of you that are aware of my story, I finally got my autococker out of my units arms room... I havent been able to use this thing since I was in Korea. Im not sure if its just because its been locked up and neglected or maybe because I lived on the ocean over there and then it spent a month and a half on a boat back to america, but when I got to look at it, my bolt was rusted to the upper chamber. I was able to wd-40 the thing and get it out, but the bolt is now pretty much junk. I used my dremel to clean out the upper chamber, and now thats all shiney again, but its probably a great deal larger diameter than it was before. So I need a new bolt. Criteria are as follows:
1. It needs o-rings to be able to seal to a larger than normal sized chamber. I definately dont have the time or the money to be able to send this thing off to get a bolt custom fit or anything like that.
2. It needs to be made of delrin, as to my understanding delrin is self lubricating. I dont know how often Ill be able to get this thing out of the arms room. and I would like to get it back un-rusted... plastic should rust.
3. It musnt be insanely expensive, and I would like it to be efficient as well. Cost is of greater concern than efficiency though, the government does not pay me well.
4. Its purchase must not financially or morally support either Yankees or Packers fans.
Thank you for your time
...And secondly, for those of you that are aware of my story, I finally got my autococker out of my units arms room... I havent been able to use this thing since I was in Korea. Im not sure if its just because its been locked up and neglected or maybe because I lived on the ocean over there and then it spent a month and a half on a boat back to america, but when I got to look at it, my bolt was rusted to the upper chamber. I was able to wd-40 the thing and get it out, but the bolt is now pretty much junk. I used my dremel to clean out the upper chamber, and now thats all shiney again, but its probably a great deal larger diameter than it was before. So I need a new bolt. Criteria are as follows:
1. It needs o-rings to be able to seal to a larger than normal sized chamber. I definately dont have the time or the money to be able to send this thing off to get a bolt custom fit or anything like that.
2. It needs to be made of delrin, as to my understanding delrin is self lubricating. I dont know how often Ill be able to get this thing out of the arms room. and I would like to get it back un-rusted... plastic should rust.
3. It musnt be insanely expensive, and I would like it to be efficient as well. Cost is of greater concern than efficiency though, the government does not pay me well.
4. Its purchase must not financially or morally support either Yankees or Packers fans.
Thank you for your time
Comment