Warp sensor not working after dye job

[than205]

Did anyone have any trouble with their sensor not working
after going through the rit dye bath? I just finished a
nice dark green fade. I dried the case and reassembled
my warp and progressively the sensor stopped working.
BTW- I have a AGD warp so the sensor is riveted to the
case and went for a soak with it. Is it likely that by
the morning it will have dried enough to start working
again? Or is the sensor toast?
Much grassy-***!

[AGD]

There is still water trapped under your sensor and it needs to dry out. Take your warp apart and hit it with a hair dryer or let it sit overnight.

AGD

[BlackVCG]

Make sure it's dry and that you got both the springs in that touch the board and the sensor. Missing one spring and it won't work.

[than205]

Warp sensor not working after dye job

Looks good this morning. Thanks.
I was worried the sensor could not withstand the heat
from the dye bath.
Tom,
I take it (this based on my fiddling) that the sensor is
resistance based?
Thanks again!

[AGD]

No its an electical generator.

AGD