Warp, Air, Marker, break down in 10 sec.- No Tools

[luke]

This setup incorporates a NW connect with a custom Warp mount for a extremely fast break down.

What do you think?

[frop]

noice! too bad I don't use a warp

[Creative Mayhem]

Looks good... I notice the small alignment pin on the warp bracket, but does the warp move around at all while together?

[luke]

The alignment pin keeps the Warp from spinning.

It seems to be sturdy. I haven't cranked every thing down "real" tight because the pieces are right out of the oven. But, even with everything not cranked down it's a tight setup....

[LudavicoSoldier]

Nice! I also use a NW QD for my warp setup. Makes transport/storage of my ULE warp mag real easy. I use a PudBudz warp bracket though.

[luke]

Cool, PB made some nice mounts.
Are you able to break down the marker, warp and air?

[LudavicoSoldier]

No, I just break the marker off of the warp/air setup. The marker goes in my AGD case and the warp/air go into my gear bag.

Since I am a lefty, with the bracket you show, I would be able to move the warp forward a little bit (mount on the rear two holes)? I dont think its possible with the right handed setup due to the electronics box. I have a NW top that I could supply for modification... Hmmmmm....

[luke]

The Warp can be mounted on either the front-middle or rear middle holes.

I only cut a few left side mount brackets, but I could cut a right mount...

[hitech]

Looks great. I think I'm going to have to change my setup (again!). My wife's not going to be happy. I'm also going to show it to my buddy with a warp...

Great job.

[luke]

Thanks HT.

[Will Wood]

That's awsome!!
I'd actually consider getting a warp again because of that..

[MonsterMag]

nice

[luke]

Thanks guys.

[atm743]

if i get a warp sometime can you make me one

[luke]

Yes, i intend to keep them instock. Check the dealers fourm.
(I haven't started a thread for them yet)