e mag software

[master_alexander]

i might get an emag in my hands with 1.35 software. but i don't know that much about the software or the emag at all. is 1.35 good? decent? i heard some talk about a 4.xx software thingey (correct termonilogy unknown) and was just wondering what i would need to do if 1.35 is not good.

so i would just like to know if i have the reight idea, or if i am wrong, or what i need to do.

thanks~

[Muzikman]

send it in, have it flashed to 3.2

[master_alexander]

send it in, have it flashed to 3.2

how much does that cost?

[Muzikman]

You would have to call and find out, but I think the flashing is free, but you will have to pay for shipping to and from.

[Creative Mayhem]

1.37 is decent, not fast, but it has other modes(burst, and F/A) 3.3 is where its at though.

[danheneise]

honestly though, with the emags hybrid mode, do you really need full auto? lol

[Evil Bob]

I believe that 1.35 might be the version with full auto, though I might be mistaken, I only remember seeing it once many moons ago. I do know for a fact that 1.37 has only the burst mode (3 to 6 balls per burst, 12bps cap when in burst mode, 18bps in semi) and no full auto option.

-Evil Bob

[Banshee23]

Flashing to 3.2 will cost you $20 total, that covers shipping & handling. You can send it to Tunaman, BlackVCG, or AGD. There's a few others too that do it, just not coming to mind right now :)

[VFX_Fenix]

1.37 is capped at 16SPS (bps) - Tuna will flash your E-Mag for free, all you need to do is pay $20 for return shipping.

[Evil Bob]

You are correct, it is capped at 16bps.

-Evil Bob

[Emag_Guy1990]

You are also correct that the 1.37 doesn't have f/a it only has 3 burst and 6 burst.

[Pudgey51]

i know its a sort of off topic but it is about emags...r they equipped with ACE (anti-chop eyes)? i read somewhere i think it was smart parts that they are equipped with the ACE feature

[kurama]

They don't need an ACE. They have the level 10 bolt which is arguably better.

[VFX_Fenix]

The E-Mag and X-Mag can both support an ACE with a daughter board. AGD did make an ACE for the X-Mag.

Level 10 and an ACE are two ends that attempt to reach the same end, elimination of chopping. The ACE is a preventative method by not allowing the gun to fire before its seen a ball and the ball's had the appropriate settle time. The Level 10 achieves this by venting gas which would have continued to push the bolt forward and fire when a ball isn't chambered entirely. The ACE is a proactive approach, Level 10 is a reactive approach.

There's nothing that says that LX is better than an ACE. If an E-Mag is equipped with an ACE that's set-up propperly it can remove the LX kit and go back to the L7 and see an improvement in efficiency and lower opperating presure.

[Pudgey51]

i saw it on nationalpaintball.com...and it was the xmag...it sounds like it has both ACE and the level 10 bolt