New Toy Came Today

[Gambit1106]

Look wat was waiting for me at the door today when I got home. I'll post info as I try it out.

Darren

[Dave]

Ooohhhh!!!!!! Very nice!!! I like a lot!!! Its very sleek looking, I like that.

-Dave

[Gambit1106]

Well first off its noisey compared to a revy. I can get used to that. Second anyone getting one becareful how you install the batteries. Reason for this is that there is a holder for the 6 AA batteries that connects to a 9v plug. When you close the door and the connector is facing up you will push the plug off of the battery pack. I found that out in the first 20 minutes of playing with it.

So far I like it. Its heavier than a revy but once again I can adapt. The feed rate visually seems faster. I'll find out when I get it on my gun with the warp and rip on the trigger.

Thats it for now.

Darren

[personman]

Preeettyyy

Preeetttyyy... *drool* Shiinnnnyyyyyy *drool* Fast Feeedddinng *drool*

[Gunga]

Be sure to let us know how well it fits on your Warp as compared to your Revvy. Did you do the 'hole mod' to your revvy for the warp hose?

[MajorDamage]

Sweet! But you don't want that! Give it to me! ME!

ENDO!

[CTG]

Gambit1106 Look at the pictures on the back of the manual, its important the connector is in the upper right corner not the lower left. Also route the wires to the side (see picture). Yes the feed rate is faster but more important is the consistency of the feed. Try it on a gun and let me know if you think its noisy.

[Gambit1106]

OH instructions, your supposed to read those? Oh look pictures too. My wife always yells at me to use instructions and I always say, "I'll figure it out". Thanks CTG I will have to go get air in the morning and shoot up the fence and see about the noise.

Darren

[Gambit1106]

Couple more pics

[Gambit1106]

from the front

[oneshot]

looks nice

[Bonx0007]

Hey that looks like it fits well. i was told otherwise. hmm
perhaps it could fit better.

[MajorDamage]

Sweet! Give it to meeeeeee!

ENDO!

[Gecko]

where did you get it from? I want to order one but don't wanna be waiting forever to get it.
Gecko

[Gambit1106]

Gecko

I ordered it about 6 months ago from www.nationalpb.com . Also I think the fit helps a bit because I drilled my warp plate to come off the gun at a 90 degree angle. It gives a bit more room to angle the warp slightly and turn the loader a bit to clear the hose. Otherwise it feeds great I looped it on my warp to feed back in the hopper. I won't have to worry about overshooting anymore.

Darren