Looking for some measurements!

[ojhspyro89]

Ok i dunno where to put this so this is what i need....

I want to know how far apart the holes on an intelleframe are. Im looking for the distance between the 2 screws that screw into the rail or whatever. Also, i want to find out how far the part behind the back hole hangs off the back.

My reason for asking is because i want to fit a Y grip to my bko. Either that or a nice vert grip just because these AGD frames are just SAWEEET!

[Chronobreak]

do the y-grips made fit bko or not?

btw i can almost guratee it WONT fit..the amt of work required would be tremendous..

[magman007]

go here

http://www.zenitram-mfg.com/

they make a y grip for the bushy

[ojhspyro89]

That y grip is UGLY!!!!

Plus, if it was too long i could fix that i have access to mills and just bout everything.

I just think that AGD frames are so smooth but darn, that z grip is UGLY!

[txaggie08]

i think it will work.....gimme five mins and ill tell you the spacing

[txaggie08]

ok whole spacing is 4 &1/8th from center of hole to center of hole. biggest issue you will have if its the right whole pattern is getting a microswitch in the frame to activate the board....