DevilMag #1

[phantomhitman]

i thought about it but it brings problems.
1-have to get new wire run from the board all the way through the frame and into the pack
2-i suck at wiring
3-no point since it fits in the frame
4-that means i could not use my dye gas thru grip if i wanted to

[phantomhitman]

and for the weight nuts here you go
gun alone,no barrel- 2.59 pounds
with barrel-2.81 pounds
this is with the cnc battery pack, so it cold be a little lighter, as well as with an uni mount that is on the way.

[BeaverEater]

Looks real nice, I might have to pick on up in a couple of months when i get some money together.

[Skywalker]

Are the eye covers supposed to be angled like that or is that the only way they could be done?

[ApexAZ]

The only reason for going with the level 7 is for better efficiency?

Would the efficiency of a level 10 be around the same as a mech RT or does the electro decrease it more?

[phantomhitman]

i have not played with a mag in so long i cannot remember how it was to begin with. the level 10 does not slow it down, i do know that. right now i can shoot to under 800 psi fine, before with my mech setup i could get to 900 psi and the level 10 would act all screwy. i will get back to you on the effeciency thing

[SCpoloRicker]

The only reason for going with the level 7 is for better efficiency?

Would the efficiency of a level 10 be around the same as a mech RT or does the electro decrease it more?

Efficiency and speed, plus not occasionaly having to tune the LX were the reasons cited by GA_Devil

/hurry. please. i'm dying. even though I cut in line

[ApexAZ]

Can someone point me to where I can find out about tuning? I assume just changing out o-rings when needed and possibly the...shim (is that what the brass thing is called?).

[phantomhitman]

there is no tuning needed for the devil, only for the levl 10. if anyhting, this gun will wear out carriers because of the excessive speed.

[Flow_Tech]

nice.

[OmniM]

Ok Colin! Start making Dallara rails to fit the Xmag batterycasing! ... where to get one of those babies ?

[ApexAZ]

sweet.

How does the trigger feel anyway?

[phantomhitman]

trigger is perfect for me. spring is enough tension to keep the bounce out while not too strong to hinder pulling fast. as far as teh actual aluminum trigger goes, it is a nice balde style that i like

[calcan311]

The lvl x bolt is friction dependent, the lvl7 isn't. So it would make sense that the lvl7 can cycle faster, require less pressure to operate, and be more consistant with velocity. For instance, when you use too tight of a carrier it causes your velocity to jump more. I would diffently use the level7. If I could find one of the delrin super bolts, I would be stoked. Looking to buy one by the way.

[phantomhitman]

i was going to but i was stupid and did not have the right parts to make it work.