Crossman shoulder stock and a sydarm...

[Evil Bob]

Anyone know if I can mount the below pictured Crossman air rifle shoulder stock onto today's stock AGD grip frame? I seem to remember that the original AGD stock grip frame was the based on the Benjain Sheridan PGP frame.

I'd like to put this on a sydarm if its a possibility.

Heck for $20 I should just buy the silly thing and find out. Here is the link for it.

-Evil Bob

[Thordic]

hrm that wouldnt be bad on a PGP.

Edit: PGP and old-school Mag grips are NOT interchangable. I have a pair of wood Mag grips I'd love to put on my PGP but it aint' happening.

[AGDJon]

Actually they should almost be compatible. Don't take my word on it fully but I had some PMI grips that were designed for the PGP only and they fit (not perfectly) onto a lone star frame (frames found on cockers and mags back in the day)

[BigEvil]

I had one of these years ago on an old skool metal AGD frame. It needed a little moding, but not that much. Having a dremel would help.

[Creative Mayhem]

I have seen that stock on many different guns, as long as it has an oldschool frame, and the single screw mount, it should work. I have been thinking of snagging one of those for years.

[space_weazel_45]

you either need to cut the space out of the stock on the bottom of the grip or cut the grip at an angle to match a PGP.
sheridan grips have no bottom line holes and so the grips are shorter and cut at an angle where as
AGD grips have a flat bottom and bottomline holes, but as far as the screw holes and mounting pins they are the same