micro switch for bushy?

[Soopa Villain17]

ok ive seen people selling them some places and the package there in says radioshack, there the 25 g switches, any no the numbers or anything so i can go over there and buy one? thanks

[Big Weapons]

https://www.paintballtrader.com

Very bouncy switch though -- make sure you set a sufficient debounce value or you'll have a runaway gun.

[Soopa Villain17]

yea but i aint paying 7 bucks to have something shiped when i go to radioshack

[Big Weapons]

Your choice. If you have eyes, make sure you ground the wires properly.

[Soopa Villain17]

yup ive got eyes , why ground it isnt it already grounded

[Big Weapons]

A couple of PDS wires are attached to the switch. I'm not particularly sure how the wiring works so I'll stop here.

[madmolly]

Hey

Man seriously don't dick with the switch. The stock switch is fast enough just practice a little. It is generous enough with bounce that with a little practice you can outshoot a halo. I would not start tearing it up for a new switch they are a pain to put in bushys.

[Big Weapons]

Depends on your trigger. My microswitch pins were really easy to remove with just a roll of tape, a hammer, and a nail. Of course, you might end up ripping a few wires out of their solder joints [ICD harnesses aren't the best in quality].

[Soopa Villain17]

ok well i messed with the trigger stuff and made it super light i can walk it so i guess i wont buy a new switch yet , ill fokus on the important stuff thanks guys

[kenndogg]

[ICD harnesses aren't the best in quality].

that sir is an understatement