Warp Karta Bodies

[yakitori]

the answer is very simple.

http://www.themagsmith.com/

Vert warp feedneck

or just get a warp ULE body.

[jewie27]

dude you have some seroise hose problems

seroisely. LOL.


I mean seriously. From the bottomline ASA it doesn't need to bend like that, just go straight up to the forgrip. From the vertical ASA to valve, you don't need to go over the powerfeed.

[JRingold]

the thing is, there is no such thing as a warp slug. There are regular slugs, not warp slugs. if you want a warp on your xmag you'll need a warp breech. unless you want to demote your xmag to an emag

No, no, no. If I bought a Warp body for my mechanical Mag new from AGD, I would get a Warp feed for free. Then I could use it either on my Mechanical Mag, or on my X-Mag, since I have both breeches for my X-Mag.

[JRingold]

seroisely. LOL.


I mean seriously. From the bottomline ASA it doesn't need to bend like that, just go straight up to the forgrip. From the vertical ASA to valve, you don't need to go over the powerfeed.

It's called working with what you have. I had the SS hose and just threw it together like that. I knew I would be changing it before it was finished so I didn't buy new lengths of hose until I was done, but I wanted it to be usable until then also.

The upper line has to go over the powerfeed, It doesn't fit below the powerfeed plug. As far as the lower line, I tried to go from the ASA to the grip with a shorter hose and it wouldn't work because it got in the way of the on/off on the asa. When I get a new body it will be better because I am going to slide the foregrip forward and get a shorter hose for the lower line. Everything will work out, eventually, until then, I am just trying to advertise for AO!

[jewie27]

actually the upper steel hose can fit under the powerfeed. mine does. just like on a stock Minimag. 4" hose is all you need.