90* quick disconect

[HoppysMag]

I need a 90degree quick disconect. (Male i think, i need the one that goes into the other one) Anyone know where to find one, or how much they are?

[Army]

uh, any paintball store will have them. Less than $10.

[HoppysMag]

o ok, cause im doin some work on my mag and would rather run nitro off remote that on gun style. and im ether gunna put the Quick disconect right to the valve or on the gas through forgrip

[toymyster]

Remember, running a remote will hurt your recharge time, and you will get shootdown !!!

[HoppysMag]

its ok i cant get my finger movin in the single trigger stock grip fast enough to cause problems,... and i only shoot really fast when its coverfire/ or im first to shoot. After that im quility over quanity.

[zads27]

Just a suggestion, but when I ran remote with CO2, I used a 45 degree SS elbow, connected to a straight disconnect fitting. Worked great for me, tucked the hose back but not straight back (into my arm)

[paintballer187]

do they make a 90* quick disconnect? or are you talking about just putting a 90* fitting on the back of a QD?

[HoppysMag]

im takin bout a 90* quickdisconect..... i thought i saw some on RT Pros at my local store, but if im wrong iwill butt it on a 90 elbow or a 45 elbow

[Muzikman]

I have never seen a 90 degree QD...your best bet is to use a normal 90 and a normal QD. This is what you more than likely saw (unless you where looking at Macro/micro line adapters).


I have never seen a difference in shoot down between running remote or ongun. The extra 20" of line will not make any difference.

[HoppysMag]

well i donno i didnt get a close look at it. but it wasnt Macro/Micro line. thats what i probibly will do.