Question for Dynaflow users - Mags only

[Eric Cartman]

[the123]

I own 2 Dynaflows and multiple mags. Keep an eye on your input pressure to your gun, if it's changing while just sitting, you probably need to rebuild it. Keep in mind however that when the Dynaflow gets low on air (less than 1000psi), it's nature is to creep up. This allows the reg to run without shootdown untill your last shots. Running the X-Valve at the lowest input you can afford keeps the velocity most consistant. my +/- over chrono, with GOOD paint, and decent barrel match, is about 3. I run 750-800 psi input. This is on my e-mags, no ULT.

[Eric Cartman]

Ooooh! That was your 666th post!

Yeah, I know that it creeps up when it's low. I'm having issues with a full fill. I'm running it at about 800 psi and the needle doesn't creep from there. I think I'm going to replace the reg seat on my valve before I rebuild the reg just to be sure it's not just my valve causing the problem.

Now if only I can find someone in Canada who sells reg seats for mags Fiding parts here can be such a hassle.

[onedude36]

can someone post a pic of an xvalve reg seat please?

[Eric Cartman]

can someone post a pic of an xvalve reg seat please?

Page three of the pdf

http://www.airgun.com/downloads/retroexploded1.pdf

[SpecialBlend2786]

+/- about 3~4 shooting around 290. Input is at 900 for my emag. no ULT

Love it.

[Kevmaster]

i WAS shooting 4-5 at 285 or so....950psi input

[SpecialBlend2786]

i WAS shooting 4-5 at 285 or so....950psi input

was?

[Kevmaster]

was?

I havnt played paintball in 2 years

[Eric Cartman]

Thanks for the input guys!