Bench grinder + Emag Trigger = Monster Blade

[MonsterMag]

I had an emag trigger than had a stripped Hes magnet set screw thingy , I hope It can be retapped now.
I got bored and milled it with the bench grinder.
Sorry for the crappy pics
What you think ao?
Gloss Black anno

[buzzboy]

Looks pretty good for a bench grinder trigger. Either anno it or give it a super fine polish.

[slade]

looks nice! although it still needs a bit of filing, a lot of sanding, and then some polishing. especially if youre gonna get it ano'd. (remember anoing something BRINGS OUT surface imperfections, powedercoat hides them)

[Maggot6]

Must have been pretty bored Good job,

[cdacda13]

looks nice.

[Army]

Been there, done that long ago!

[rifleman wi]

wont the screw stick out alot out of the front of the trigger? i had my friend dremmel down the front of my stock trigger and the screw stuck out alot and kinda got in the way...


army- nice emag.. what color is that.. looks orange..

[Automaggot68]

You did a horrible job, it's too sloppy.
I've done better jobs with a file.

[MonsterMag]

Nice army , I am gonna tap and put a set screw in there, a smaller one so it wont stick out.
Automogit , you never anything posative to say , so dont say anything.

[MarkM]

What you think ao?

You did a horrible job, it's too sloppy.
I've done better jobs with a file.

Automogit , you never anything posative to say , so dont say anything.

Whilst it could be said it isn't a very neat job for the tool you used it is far from finished, you did as AO for input (1st quote)

You and Automaggot68 do have a history and it is obvious you dislike each other but you can't have it all ways with this, you asked for input and can't complain when you get it, you never know Automaggot68 might have actually been honest with his reply I don't think it is that neat either.
Do the job by all means but show a picture of the finished article. I have a couple of triggers that I am thinking about doing some work on but I won't post a picture unless it is very smooth.

[MonsterMag]

Whilst it could be said it isn't a very neat job for the tool you used it is far from finished, you did as AO for input (1st quote)

You and Automaggot68 do have a history and it is obvious you dislike each other but you can't have it all ways with this, you asked for input and can't complain when you get it, you never know Automaggot68 might have actually been honest with his reply I don't think it is that neat either.
Do the job by all means but show a picture of the finished article. I have a couple of triggers that I am thinking about doing some work on but I won't post a picture unless it is very smooth.

its not done yet ,I am gonna sand it and buff it , kinda like a step by step thread

[Automaggot68]

Automogit , you never anything posative to say , so dont say anything.

You never have anything GOOD to post. You couldn't even spell my name correctly, and it was right in front of you on the monitor.
You cant post anything on here, and ask 'What do you think of this' and expect to NOT get flak.
Suck it up.

[atm743]

WOW

that looks good looking at the trigger face

i must try it out

and if i like it mabey you can do it to mine

[MonsterMag]

Thanks guys , I need to make a few improvements to it. I wanna go for the smooth curvey look.