I need HELP with my warpfeed

[bojangles1983]

My warp feed battery cable came loose at the soldering point on the board last night. I thought this would be an easy fix, just reattached it with a little bit of solder. But I am still not getting any power to the warp. I am trying to reattach the + and - leads coming from the battery housing to the PC board. I attached the red + line to the PCC and the black - line to the GND. Seemed simple enough but no power, and yes my battery is charged Any advice would be great, or if there is someone out there with a good board with lines attached I would be interested. Thanks Guys!

[Chronobreak]

did you attach the wires correctly?

+ to +

- to -

double check just incase

[master_alexander]

make sure you used the soder that conducts electricity, for some reason my friend had a specail solder that he used and it was a pain in the butt to fix.

and look up a schmetic on the airgun page or just put some pics up and someone can probably figure it out.

[bojangles1983]

just went out and redid the solder and lines, I think one of my battery lines was crimped or maybe my soldering wasnt the best because now she works fine. Thanks for the help guys.