i have an old maxflow(not sure of the year) and it has a tank on it that i would like off but it wont come off..no matter how hard i try what can i do?
-
-
Take it to a Scuba shop or ...Airsmith to have it removed.
They both have the proper tool to remove stubborn regs.
By the way ...hehe...Is it a 1st gen MAX FLOW or a later version?
Im looking for a 1 st gen reg "cap" (only has the 1 hole for the bleed off)
" Remember what the door mouse said..."
-
umm ok sorry if i dont make sence
you screw in the tank then theres a gage then it goes down to another tube like aread then a gage and then a hole at the tip lol sorryComment
-
Hehe, SOrry I was the one that wasn't clear.
I am talking about the end cap ...the adjuster Does it have just the hole where the copper colored filter is at the very end , OR does it have multi holes along the cap?" Remember what the door mouse said..."
Comment
-
lol oh ok where the fitting goes in it is on the right hand side then on the top of the adjuster theres a hole and also on the left hand side toComment
-
Bring it to your local shoppe.
Edit:
Hell you know what?
Listen to the above buffoons and tell us later what happened.
Make sure there's air in your tank when following their directions.
/end sarcasmComment
Comment