Classic Valve on RTP rail?

[GT]

Any of you guys give this a try? I would think you would need a longer on/off pin but I dunno....

[Jonno06]

rtp's have a banjo bolt, which im 90% sure would get in the way.

Any of you guys give this a try? I would think you would need a longer on/off pin but I dunno....

[GT]

rtp's have a banjo bolt, which im 90% sure would get in the way.

rtp's do not have a banjo bolt. Rt's do... Come on man you have like 4k posts

[Tigwldr]

I am thinking of doing this very same thing. What would need to happen or this to work? I hope there is a way to do it. Would the rail need to be modified or something.

[GT]

I am thinking of doing this very same thing. What would need to happen or this to work? I hope there is a way to do it. Would the rail need to be modified or something.

no it will bolt right on, what I am concerned with is the length of the on/off pin. not sure if the stock classic is long enough. There should be some old AO dude that can answer this question.

[Tigwldr]

I am very new to Mags so I am not sure what the on/off pin is. I have seen a pic somewhere in all my searching the last few weeks with the very setup we are discussing but I am not sure where I saw it or whos it was.

[lbonettosd]

To the best of my memory, I believe you will need an on/off pin that is .765" instead of the stock .750". Of Course I could be wrong.

[Tigwldr]

Do you have a picture of this pin and where it goes? Where do you find these parts at? Can I get one from AGD or do I have to post wanting to buy?

[Jonno06]

sorry about the mix up, its been awhile since ive had a mag.

[CoolHand]

It will work just fine.

If you use the ULT, you will have to retune it, but I have run Classics on RTP rails many times, with the stock On/Off, and never had a problem.

[personman]

Just put the rtp on/off in the classic valve

[dynastyfan]

thats how i ran my mag when i had the rtp rail. it worked fine no problems what so ever. but i have since moved over to a mm rail for size and different body

[GT]

It will work just fine.

If you use the ULT, you will have to retune it, but I have run Classics on RTP rails many times, with the stock On/Off, and never had a problem.

has anyone tried milling out the on/off section to except the ult. I have run a ULT before and it barely fit back into the body.

[Destructo6]

I have a Classic valve on a Rogue RTP rail and it fits and functions quite nicely.