Lighter Trigger Pull/ Shorter

[SPECK]

My mag has the 68 Classic Valve. At Michigan Monster Game I purchased the "Reactor Kit" and installed it and it seems to help a little. Not much though.

So, what can I install KEEPING CO2 IN MIND, to make my trigger pull lighter/ shorter?


Thanks

Also, do Powertube Spacers help at all? As in make anything nicer?

What about an AIR Valve or something?

[ultralight]

well, first, the classic valve is the same as the A.I.R. valve. as far as a lighter/shorter pull you could try the ult and luke's sear mod (don't worry, he doesn't even touch the part that touches the bolt). but you have to make absoluetly sure that you keep liquid co2 out of that marker. i would recommend an expansion chamber and an anti siphon tank or a remote line.

i hope this helped, lots of luck.

[Asym]

I installed a ULT in my classic and used CO2, worked ok but I was using a Palmers stabilizer and CO2 was reg'd down to 750PSI into the valve. I just recently switched to HPA and just about done with a spidermag conversion(ramping chip just came in) and it works great. I've been wanting to slap the stabilizer back on and see if it works fine on CO2, only reason I haven't is with the HPA input of 850 it should recharge slightly faster.

Powertube spacers only work if your using a level 7 setup, it allows you to get the right size spacer for the oring so it seals around the bolt without leaking. If you have a level 10 bolt you use carriers and spacer shims.