Morlock Board Problems

[mobsterboy]

its crapped out, give it to me, and then go buy yourself the new logic frame

[SpitFire1299]

Pff.. no!

Isnt there a way to reset the board?

[onedude36]

hmm... look at this nice 20 bps board ive got sitting here... mmm sooooo tasty...

how much did u pay for your morlock? i paid like 60 for my board. Thats a cheap morlock..

*has nothing to add to the conversation*

[SpitFire1299]

Uhh.. so does anyone know how to reset it?

[CoolHand]

Alright.. Ive got it working, but its in full auto mode.. It wont come out of it either.

Set register 1 to 1 (which is semi-auto).

And no, there is no reset for a Morlock or Predator II.

[SpitFire1299]

Set register 1 to 1 (which is semi-auto).

And no, there is no reset for a Morlock or Predator II.

It doesnt work..

[SpitFire1299]

Arg.. tournament tommorrow, It still just wont come out of full auto no matter what i do. I wish you could reset all the registers to default. I tried myself, but it doesnt work.

[CoolHand]

Arg.. tournament tommorrow, It still just wont come out of full auto no matter what i do. I wish you could reset all the registers to default. I tried myself, but it doesnt work.

Check to make sure the tournament lock is off.

Both little dipp switches should be OFF.

If that doesn't do it, I have no idea.

[SpitFire1299]

Yeah, its for sure stuck. It works great, but only works in full auto mode.. Maybe it was just a simple programing error. If the board gets re-flashed i bet it will be fine.

[WARPED1]

Sell it all and buy yourself a Shocker or Proto.

[SpitFire1299]

Sell it all and buy yourself a Shocker or Proto.

Nah.. then ill be like everyone else around here.

[FallNAngel]

And no, there is no reset for a Morlock or Predator II.

I know the pre-5.0 AFA code boards *did* have a reset. Hold the trigger back and turn the gun on... continue holding the trigger back and after about 5-6 seconds, it should flash several times while it resets. If you have a newer coded board, you may not have this feature.

[11 Bravo]

Programming

To reset the Morlock to its factory defaults, hold the trigger down, then turn the power on/connect the battery. Continue to hold the trigger down for a good 6 or 7 seconds. The light will flash, turn off, then blink 5 times indicating a factory reset.

[11 Bravo]

Yeah, its for sure stuck. It works great, but only works in full auto mode.. Maybe it was just a simple programing error. If the board gets re-flashed i bet it will be fine.

Did u adjust the debounce?

[CoolHand]

Did u adjust the debounce?

Yes, check the debounce. The Pred code uses 1/4 ms increments for debounce, so if you set it to 5, you really only have a debounce of 1.25ms, which is not enough.

Set the debounce to about 25 (that would be 6.25 ms) and see if that helps tame it down. If 25 won't do it, try 50 (12.5ms), if THAT won't do it, replace the trigger switch.

That is of course assuming that you really have it set to semi-auto in by setting register #1 to 1.

If it won't take any programming, then the tournament lock is on. Turn both little dipp switches on the board to "off" and try again.