E-Bladed Mag?

[Makarov]

Sorry if this has already been covered...

I was thinking - Mags and snipers used to use the same grip frames, right? Or is it just the screw pattern?

Well, if they were/are directly compatible, then could you use an e-Blade frame to hit the on/off? If so, this could be a slightly "higher class" version of tripping the sear, as opposed to hypermag and spyder frames.

I don't own an cocker or a mag (yet), so I don't really know what would happen.

[gortman44]

yeah, but you would have to do allot of modding. i looked at it and just went with the spider cause it was way way easier

[Mr. Mouse]

i remeber seeing apicture with a mag with a eblade on it and had somethin to do with mq-valve

[Indignant]

Search "Agg-mag"

[Arstron]

You could spydermag a eblade frame, but a t-boarded spyder frame would perform just as good. You can get spyder frames quite a bit cheaper then a eblade as well.

as for bolting an eblade to a mag and sooting, it wouldnt work. The eblade would have to be turned 90* to point to the rear of the frame and would still have to work like a spyder-mag frame.

[pachytriton]

electro y grip

lol

[*ArKfEaR*]

[onedude36]

not a mag. m-q valve in a mag's body/rail.

[personman]

not a mag. m-q valve in a mag's body/rail.

yep.

eblades wont work on mags. you'd have to do some SERIOUS HEAVY modification to get it to work, and even after alot of work I doubt you could get it to fit well/work reliably. Not to mention it would be a complete waste of money seeing that one of the reasons the eblades are so expensive is that they come with 2 solenoids/enough stuff to run a two solenoid config. Mags only need one and the one in the eblade isnt set up right for a mag.

This is one of the only cases where a $30 spyder frame is > the eblade.