Yeah i posted this on PBN but, i figure i'll post it here to see if you brainy types might have a solution or a general direction. I would of posted this on the intimidatorowners group, but i just didnt want to start a new account.
Is it feasible to modify the existing Alias LPR to not go over XX psi?
Is there an LPR on the market with that feature? I was thinking of LPR on the EGO and its self limiting design.
Granted, if the reg were to develop a bad reg seat it still might creep past whatever pressure its limited to, unless i suppose, you can engineer an LPR that outputs at 95psi max, then a bad reg seat shouldn't matter.
With this, i figure you can loose the LPR guage knowing you wont blow a noid due to an undetected reg creep and possibly improve the ergonomics of the gun a little bit.
thoughts?
Is it feasible to modify the existing Alias LPR to not go over XX psi?
Is there an LPR on the market with that feature? I was thinking of LPR on the EGO and its self limiting design.
Granted, if the reg were to develop a bad reg seat it still might creep past whatever pressure its limited to, unless i suppose, you can engineer an LPR that outputs at 95psi max, then a bad reg seat shouldn't matter.
With this, i figure you can loose the LPR guage knowing you wont blow a noid due to an undetected reg creep and possibly improve the ergonomics of the gun a little bit.
thoughts?
Comment