'RF Cocker?

[mastershake44]

Ok, well, i went gun hunting, and, at the shop here, the cocker tech has a 99 RF with ANS Pneus. He said hell sell me that and an AA Tank and the original Vl Revolutionfor $150
(Gun, VL Revolution, AA Tank)

[neppo1345]

Sounds like a good deal to me...but then again...I love cockers and will always rescue one in need...

[WARPED1]

Sounds like a good deal.

[paint magnet]

Make sure the gun works and the tank is in hydro.

[warbeak2099]

Go for it. Sounds like a decent deal. Yea, do make sure the gun actually works and the tank is in hydro. Also make sure that the tank reg is in working order.

[skife]

the revvy is worth 30 at least.

Pre-be shells are great.

[WARPED1]

I think 1999 was the last year ANS used WGP bodies for thier cockers, they make "fockers" now, not that that's a big deal really.

[mastershake44]

no, its a WGP Body, but, ANS Pneus. Both work, and the tank is in hydro

[minimag03]

I'd buy it if I was looking for an Autococker. You know it will work and be in good condition since he is a cocker tech. My only problem is with the older ANS Pneus. Their 3way wasn;t too great and the ram was a very cheap copy of the STO. However, they get the job done.

[WARPED1]

Get it drilled for eyes and slap on an E2!

[minimag03]

It would be hella hard to milled a RF for any Eblade. That just gave me an idea for a project. a LF Ebladed cocker...hmmm

[WARPED1]

It would be hella hard to milled a RF for any Eblade. That just gave me an idea for a project. a LF Ebladed cocker...hmmm

It wouldn't be any harder than any other cocker.

[soccer4minimags]

It would be difficult. The eye is supposed to go where the feed neck is on the right side. the eblade eye needs to be 90 degrees from the feed, making it belong somewhere on the site rail. You can't do it on the left cause of the detent. I have a right feed with a e1. When I got it I enquired with Planet Eclipse about this. This is when e1's were new, they said they were working on a template or something so you could install it on the right feeds. Its been a few years since, nothing yet, I guess the demand is low. I haven't found anybody to do it for me.

Most the guys I know with eblades don't use the eyes anyways. If you have a halo and just adjust your setting accordingly you will be okay.

There was a guy on PBN that installed eyes on his RF.

[Mastershake99]

In my opinion you can't go wrong with any cocker. I would keep it as a good backup for a rainy day to keep those electronic markers out of the rain. Might not be the fastest but you know you wont have a problem with accuracy.