adjusting a t boards settings

[superfreakmabsta]

--------------------------------------------------------------------------------

can anyone explain to me how to adjust the ramping settings on my t board with the ramping chip. i have one in my hyper frame and want PSP legal ramping( ). how do i go about this.

thanx

[11 Bravo]

What is the name of the chip that you have in it?

[luke]

[superfreakmabsta]

it is a ramping chip for the spyder t board, that is all the packaging says.

and luke, ah what you saying. did i break a forrum rule

[11 Bravo]

Just go to scenariodreams.com and look it up under manuals.


edit: Sorry, I had my son get on here under my name to help you out. He can program his Tboard in his sleep. But I guess he's worthless when it comes to helping someone out.

[neppo1345]

Rtfm

or ask someone on pbn...since you seem to like it over there so much PM Damonwill...he makes them...i'm sure he'll be G-L-A-D to answer your question...

[Arstron]

Example1: Turn on the marker with the trigger held down until the LED blinks once, release trigger, pull trigger 24 times (Dwell), hold trigger until the LED turns off, release trigger, pull the trigger four times (Eye Delay), hold trigger until the LED turns off, pull trigger twice (Debounce), hold trigger until the LED turns off, pull trigger four times (Eye Disable), hold trigger until LED turns off, pull trigger until LED turns ON (Eye Type), hold trigger until LED turns off, pull trigger until the LED turns on (Ramp enabled), pull and hold trigger until the LED turns off, pull trigger four times (Trigger Speed), pull and hold trigger until LED turns off, pull trigger once (Time to Ramp), pull and hold trigger until LED turns off, pull trigger 7 times (Ramp Speed), pull and hold trigger until LED turns off.

Marker is ready for play with a 24ms (2+1+1+1...etc) dwell, a 20ms (5+5+5+5) eye delay, a 4ms (2+1+1) debounce, 2 sec (? + ? + ? + ? sec) hold needed to disable the eye, Breakbeam eye, Ramping enabled, a 8bps Trigger Speed (4+1+1+1+1), 1 sec Time to Ramp (.5 +.5), 16 bps (9+1+1+1+1+1+1+1) Ramp Speed.


This is the manual for the spyder ramping chip that you will probably want to print out. Dont let all this intidate you though, it really isnt that bad. Just rember once you enter the setup mode and start chaning 1 setting, that setting returns to its minimum state. So if you have the dwell set at 10, when you enter the dwell setting and pull the trigger once, this will set the dwell to 2 and not 11.

btw, if I read that manual right, ramping should be enabled as soon as you install the chip...

[warbeak2099]

it is a ramping chip for the spyder t board, that is all the packaging says.

and luke, ah what you saying. did i break a forrum rule

Yes you did. You posted this same topic in the Tech section. Delete one of them, you're not allowed to post a thread in multiple sections.

[superfreakmabsta]

so do i have to go through all of that to adjust it. right now it ramps at a low bps. and sure i will delete the other thread. im sorry wasnt aware i was breaking a rule. i plead ignorance