Need help quick, on site at Proj Red Eye!

[Meph]

Hey guys. I don't have much time to do the searching around. I hate having to do this knowing the info is there.... any ways. We are working on one of our Automags. We are doing the SpyderMag project! It's a spyder frame on an automag.

We have an e-mag valve, and a ULT. ULT area needs to be bored out.

What is the exact depth that we need to bore out the on/off assembly area so it seats/seals properly?

Thank you guys in advance!

[Potatoboy]

The step needs to be removed. In your valve you should see three steps, mill the highest step even with the middle one, leaving the center divot intact.

Be sure not to nick the sides of the on/off area or you won't seal.

And the mQ valve should be coming tomorrow with Chris' name on it.