Help needed with DM5 (trigger)

[BunkerBoy848]

I have a prblem with my DM5 i just got a new trigger for it but i con't get the old one out. The pivot pin/rod that the trigger well pivots on is stuck and I can't get it out. I would perfer not to use alot of force to get it out...any suggestions?

Thankx

[Pyroboy597]

Take a nail or a thumb tack and press it against the pin (ONLY IF YOU HAVE IT OUT PART WAY ALREADY) and then bang it with theh back of a spoon.

[magman007]

you are going to have to give it a few good solid whacks to get the trigger pin out. i reccomend using a center punch, and a light hammer, and giving it a few whacks, which ever side bidges, hack a few more times, if i recall correctly, you hit from the right hand side of the marker, the led side is the side the pin should come out. dont be affraid, just be safe.

[buzzboy]

Take your gun and put it on a roll of tape. This allows a place for the tiggerpin to go. Then use a center punch and a light hammer. Don't be scared. You won't hurt anything. What trigger did you get.

[BunkerBoy848]

Thankx

Thankx for all the suggestion I will try them and post the results soon

[RRfireblade]

It might take some force so be careful...many of the DMs I've worked on have locktite all over the trigger pin from the set screws (sloppy) .

I will come out though , do it on a SOLID surface and put a piece of tape (masking) over the whole pin and use a center punch on the pin which will indent it and keep you on it , the tpe will help keep from sliding off the pin when you hit it. Once you break it free it should come easier.

[BunkerBoy848]

thankx for all the help I got it out useing a hammer and a piece of aluminum with a hole in the middle and the new one whent in easy as pie..