Tuning automags

[JAKEtheJAB]

[grEnAlEins]

1) Oil, replace orings if needed (charge your emag when needed ) and add/remove shims for lvl 10 and ult and switch carriers for lvl 10 so that they operate to your liking
1)B) Shims are little pieces of metal that look like washers just super skinny.
2) take some two sided tape and tape a paintball to a pencil. Hold the ball halfway in ans halfway outof the breech. Pull trigger. If the bolt "chuffs" and resets you have level ten. If it chops you do not have level ten, but you do have a mess

Hope it helps, good luck with the mag,

Nick

[JAKEtheJAB]

1) Oil, replace orings if needed (charge your emag when needed ) and add/remove shims for lvl 10 and ult and switch carriers for lvl 10 so that they operate to your liking
1)B) Shims are little pieces of metal that look like washers just super skinny.
2) take some two sided tape and tape a paintball to a pencil. Hold the ball halfway in ans halfway outof the breech. Pull trigger. If the bolt "chuffs" and resets you have level ten. If it chops you do not have level ten, but you do have a mess

Hope it helps, good luck with the mag,

Nick

Thanks Nick, what are the function of the "little pieces of metal that look like washers"? What does it mean to "switch carriers for lvl 10"?

[grEnAlEins]

Thanks Nick, what are the function of the "little pieces of metal that look like washers"? What does it mean to "switch carriers for lvl 10"?

Level ten guide is super helpful, check it out. I got my level ten running fine after reading it and a few posts.

Hope that helps,

Nick