I'm talking about the 90 degree adapter that goes on vertical feed markers. My question ids about the other end of the adapter after its been put on the gun, the end where the warp hose would go. If anyone has one of these, can you get me the inner diameter of this end? Thanks.
-
-
The inner diameter of the male or female end. Why do you need to know. I had enough trouble getting my warp set up I can probably help you. -
The inner diameter of the end that isnt on the gun body, the end THAT attached to the warp hose.Comment
-
I'm not sure exactly seeing as I don't have my calipers handy. I can measure it and get back to you though.Comment
-
I have a similar question. For vert feed guns, what do you guys use for the piece of plastic "pipe" that sits in the feedneck. It should be the same diameter as a standard hopper neck, but just trying to get ideas before heading to Home Depot looking for pipe. If I can't find plastic or PVC, I wonder if a short length of metal pipe is an option. Then I'd have to buy a pipe cutter though.
What I'm concerned about is that if the pipe (plastic or whatever) edges are rough/sharp...it could break balls as they flow through the 90 degree adaptor and into that pipe.
Thanks.Comment
-
rpg
Originally posted by AslanI have a similar question. For vert feed guns, what do you guys use for the piece of plastic "pipe" that sits in the feedneck. It should be the same diameter as a standard hopper neck, but just trying to get ideas before heading to Home Depot looking for pipe. If I can't find plastic or PVC, I wonder if a short length of metal pipe is an option. Then I'd have to buy a pipe cutter though.
What I'm concerned about is that if the pipe (plastic or whatever) edges are rough/sharp...it could break balls as they flow through the 90 degree adaptor and into that pipe.
Thanks.
go to the magsmith.com they have a vert warp adapter..it is for vert feed guns..and it works with the elbow that comes with the warp
BEO MAFIA
sigpicComment
-
The inner diameter of the tube where the warp hose adapter goes on to is .740-.745. About .862 -.865 on the outside.Comment
-
shave the nut/bolt part off the female end of the elbow and it will be about the same size as a vl 200 hopper neck.Originally posted by AslanI have a similar question. For vert feed guns, what do you guys use for the piece of plastic "pipe" that sits in the feedneck. It should be the same diameter as a standard hopper neck, but just trying to get ideas before heading to Home Depot looking for pipe. If I can't find plastic or PVC, I wonder if a short length of metal pipe is an option. Then I'd have to buy a pipe cutter though.
What I'm concerned about is that if the pipe (plastic or whatever) edges are rough/sharp...it could break balls as they flow through the 90 degree adaptor and into that pipe.
Thanks.Comment
Comment